domingo, 4 de abril de 2010

How to make an ethernet cable (twisted pair)

With the arrival of a new floor, we have seen with the disadvantage that wiring had to be done in order to have all Internet. So now we have work the cables I decided to make the report a bit on how to make ethernet cables correctly, because in many websites and blogs explain it, but so too technical, so I decided to do a tutorial in a way more direct.

The first step is to gather the necessary materials displayed on the next photo.
Obviously the first thing we need is the cable (a bit simple, but I had to say), a crimper, it's that kind of key you see in the picture, worth between 10 and 20 euros, but from my point of view is a good investment and RJ -45 pin 8-pin.
The next thing to figure out is how we should run the wires before inserting into the pins, and this we can see in the picture below.
As you can see the sequence is (WHITE-ORANGE), (ORANGE), (WHITE-GREEN) (BLUE), (WHITE-BLUE) (GREEN), (WHITE-BROWN) and (BROWN). It should be noted that if we want a cord to connect to the internet, we must put the same lineup for two extremes, but if on the other hand we need a cable to communicate computer to computer, so we have to do is put at one end indicated and training At the other end the same formation but in reverse. Once you have the proper training thin wire we have to do is to put in the plug and with the help of the crimping press the plug to fit the thin wire.
If anyone has a problem do not hesitate to put it in the comments and try to solve.

3 comentarios: